TI中文支持网
TI专业的中文技术问题搜集分享网站

XDS100V3.0仿真motoware自带工程的操作问题

如题,在购买DRV8301-69M-KIT套件并一系列测试后,自制了板子,核心为28069+DRV8301,留的是14P的JTAG接口,仿真器为XDS100V3.0

上电后,通过UniFlash,可以对芯片进行下载、读取等操作,说明硬件连接没问题;

工程选用motoware自带工程,例如proj_lab5.0等,debug时候连接不上,提示没有识别。如图

接下来,我打开工程内的TMS320F28069_xds100v2.ccxml,添加了XDS100V3.0,并在它下面添加了28069器件,点击“Test Connection”,测试过程及测试结果正常,如下:

The JTAG IR Integrity scan-test has succeeded.

—–[Perform the Integrity scan-test on the JTAG DR]————————

This test will use blocks of 64 32-bit words.
This test will be applied just once.

Do a test using 0xFFFFFFFF.
Scan tests: 1, skipped: 0, failed: 0
Do a test using 0x00000000.
Scan tests: 2, skipped: 0, failed: 0
Do a test using 0xFE03E0E2.
Scan tests: 3, skipped: 0, failed: 0
Do a test using 0x01FC1F1D.
Scan tests: 4, skipped: 0, failed: 0
Do a test using 0x5533CCAA.
Scan tests: 5, skipped: 0, failed: 0
Do a test using 0xAACC3355.
Scan tests: 6, skipped: 0, failed: 0
All of the values were scanned correctly.

The JTAG DR Integrity scan-test has succeeded.

[End: Texas Instruments XDS100v3 USB Debug Probe_0]

然而,再次点击debug,还是连接不上,请问,应该如何操作呢?

Green Deng:

你好,再次debug连接不上,出现的问题还是Error – 151吗?
"添加了XDS100V3.0"是添加还是更改了配置?
同样的仿真器在官方板子上能否正常烧写?

Green Deng:

回复 Shan:

感谢反馈!

赞(0)
未经允许不得转载:TI中文支持网 » XDS100V3.0仿真motoware自带工程的操作问题
分享到: 更多 (0)