TI中文支持网
TI专业的中文技术问题搜集分享网站

28335JTAG连不上(急!项目时间紧希望各位大侠帮帮忙)

问题:DSP上电后,复位引脚周期性的输出低电平,周期大概为224HZ这样。JTAG无法连接,报错:is recommended to RESET EMULATOR.  This will disconnect each  target from the emulator.  The targets should then be power cycled or hard reset followed by an emureset and reconnect to each target.  
Error connecting to the target: Error 0x80000200/-1031 Fatal Error during: OCS,  Device driver: Problem with the Emulation Controller. It  It is recommended to RESET EMULATOR.  This will disconnect each  target from the emulator.  The targets should then be power cycled or hard reset followed by an emureset and reconnect to each target。

检查:1、检查所有DSP电源引脚,电源没有问题,均正常(3.3和1.9都正常。)

             2、检查复位芯片,没有问题,断开DSP复位引脚,其为高。

             3、检查输入时钟,没有问题,30MHZ

              4、将DSP的复位引脚强制高,测试复位引脚,无低电平输出,但是JTAG无法连接。

             5、去掉时钟,复位引脚为高,无低电平输出,但是JTAG无法连接。

现在我的问题是:1、JTAG的连接与复位引脚是否有关联,像我这样,复位引脚有周期性的低电平输出是否会导致JTAG无法连接?

                                 2、我觉得应该是内部看门狗动作,导致复位引脚周期性复位,但是这个会导致JTAG连不上嘛?

                                 3、如果JTAG连接无复位引脚无关,那么是不是JTAG坏了?

                                 4、如果有关联,那么是什么原因导致会产生这种现象,是不是可以认为是片子坏了?

wang zhe:

补充一下,仿真器没有问题,已经连过其他板子了

赞(0)
未经允许不得转载:TI中文支持网 » 28335JTAG连不上(急!项目时间紧希望各位大侠帮帮忙)
分享到: 更多 (0)