CC 2642R and CC 2652R

Dear,

Would you please help to answer the following two question? many Thanks

1,  I use RF Studio 7.0 to open CC2652R, the first time,I don't know what parameter I setted at device control panel.  but I didn't open device control panel. it show:

    incorrect PA setting Value, Current file: pasettigs_New target.xml, device:CC2652R_PG11. how to open device control panel?

2, for BLE 5.0 RF pHY test, How to set different payload at device control panel?  BLE standard need set PRBS9,PRBS15, pattern: 01010101 etc. as below

Viki Shi：

1、建议把TI的软件和工具安装到默认路径，不要包含中文
2、修改PDU请参考： dev.ti.com/…/index.html

user5931974：

回复 Viki Shi:

Dear Viki,
谢谢~
Q1： 我已经使用此软件，前一段时间，能够使用此软件打开device control panel界面去控制TX,RX连接，但是最后一次，我不知道修改了什么，结果打不开device control panel界面，打开RF Studio 7.0,出现错误，显示为：incorrect PA setting Value, Current file: pasettigs_New target.xml. 请问怎么恢复呢？
Q2: 怎么使用RF Studio 7.0去设置不同的PDU Payload如PBRS 9,PBRS 15,01010101等，请问RF Studio 7.0哪个地方可以设置呢?您发的 dev.ti.com/…/index.html，我没有找到RF Studio 7.0的相关设置哦，

麻烦您~
Vick Wu