TI中文支持网Part Number:DRV8306
There's one more question I want to ask.
It is on your official evalution board, The HPx is connected to the DVDD by pull-up resistor, and the HNx is connected to the DVDD/2 by divider resistor.(single-ended Halls signals)
For me, I connected the HPx to the DVDD by pull-up resistor too, but I connected the HNx directly to GND.
Is there any problem with this connection ?
Is it possible that because of this connection caused the motor can not start with load?
Cherry Zhou：
Hi,
We will keep follow up on the link below so closing this thread:
https://e2echina.ti.com/support/motor-drivers/f/motor-drivers-forum/785852/drv8306-it-is-diffcult-to-start-the-motor-with-drv8306/2884997#2884997
