TI中文支持网
TI专业的中文技术问题搜集分享网站

IWR1443BOOST: Unable to send .cfg files to IWR1443 properly through MATLAB.

Part Number:IWR1443BOOSTOther Parts Discussed in Thread:IWR1443

Hello friends, I have encountered a tricky problem.

    I am sending .cfg configuration files to an IWR1443 development board through MATLAB, which allows the radar to collect data. However, after successfully sending the .cfg file once and the board working correctly, MATLAB is unable to send the .cfg file to the board, or the process of sending the .cfg file is very slow (taking more than 20 minutes).

   The first time the .cfg file was sent to the board, everything worked normally

After that, MATLAB's program is unable to send .cfg files to the development board normally。As shown in the figure below, it seems that MATLAB did not send the configuration file to XWR1xxx 11.cfg properly.

                                                                                       I sincerely hope that my friends can provide valuable suggestions!Thanks!

Shine:

请在您的另外一个帖子里讨论。https://e2echina.ti.com/support/sensors/f/sensors-forum/695938/iwr1443boost-matlab-cfg-1443

赞(0)
未经允许不得转载:TI中文支持网 » IWR1443BOOST: Unable to send .cfg files to IWR1443 properly through MATLAB.
分享到: 更多 (0)

© 2024 TI中文支持网   网站地图 鲁ICP备2022002796号-1