TI中文支持网Part Number:TDA3MV
您好！
根据VisionSDK_UserGuide_TDA3xx的19页，成功运行
。。。。。。
************QSPI flash completed sucessfully**************
但是到了：4. Reset the board and Repeat step 1, 2, 3 .这里，连接Connect M4时，报如下错误：
Cortex_M4_IPU1_C0: GEL Output: ==================================================
Cortex_M4_IPU1_C0: GEL Output: ========= TDA3xx PG3.0 device detected =========
Cortex_M4_IPU1_C0: GEL Output: ========= TDA3xx GP Device detected ===========
Cortex_M4_IPU1_C0: GEL Output: ========= TDA3xx 15×15 Device detected ===========
Cortex_M4_IPU1_C0: GEL Output: ==================================================
Cortex_M4_IPU1_C0: GEL Output: —>>> All Control module lock registers are UNLOCKED <<<—
Cortex_M4_IPU1_C0: GEL Output: —>>> Changing RTI1 reaction type to avoid RTI1 resetting the device after 3 minutes… <<<—
Cortex_M4_IPU1_C0: GEL Output: —>>> Starting IPU A-MMU configurations… <<<—
Cortex_M4_IPU1_C0: GEL Output: —>>> IPU A-MMU configuration completed. <<<—
Cortex_M4_IPU1_C0: GEL Output: ——————————————————————————————
Cortex_M4_IPU1_C0: GEL Output: —>>> DDR and DPLL configuration Based on Package selection pin status(Sysboot[7]) <<<—
Cortex_M4_IPU1_C0: GEL Output: ——————————————————————————————
Cortex_M4_IPU1_C0: GEL: Error while executing OnTargetConnect(): Target failed to read 0x4A0026C4
at silicon=*((unsigned int *) 0x4A0026C4) [TDA3xx_startup_common.gel:81]
at OnTargetConnect()
Shine：
请问有没有按板子的reset键？时间按长一点看能否解决？
,
user6408303：
单板断电后，重新上电，重新连接，还是报这样的错误
,
Shine：
请问是自己的板子还是TI的EVM板？ processor SDK是最新的版本么？
