TI中文支持网您好，
在C6748上，从flash烧录后重新上电无法启动，需要手动硬件复位之后才可以，请问可能会是什么问题？或者有什么手段可以查看bootup状态？
谢谢
Nancy Wang：
上电时请看一下电源/时钟/复位信号是否正常。具体请阅读手册 6.3 Power Supplies / 6.4 Reset 章节。
www.ti.com/…/tms320c6748.pdf
无法启动时读取BOOTCFG的值看一下启动模式的值是否正常。
C6748烧录后重新上电无法启动，需要手动复位
未经允许不得转载：TI中文支持网 » C6748烧录后重新上电无法启动，需要手动复位
相关推荐
AM62A7-Q1: gpio设置异常- AM6422: How to relocate the Exception Vector Table in the MCU R5
- TMS320C6678: 核0启动核1，核1没有运行起来
- TMS320C6678: TMS320C6678网络中断问题：核0创建任务后Ping失败
- TDA4VM: During DSP6678 debugging, after creating a print test task on Core 0, the previously functional network connection was interrupted with the error: Destination Host Unreachable.
- AM62P: The issue of poor performance when the MNN(alibaba Mobile Neural Network) inference framework calls the GPU for inference via OpenCL.
- TMS320C6678: C6678CSL库EDMA3的AB同步传输无法启用除0通道以外的别的通道
- AM6442: [IPC RPMSG] Message send to remote core 5 @ 16 end point truncated due to lack of space in vring buffer !!!
![AM6442: [IPC RPMSG] Message send to remote core 5 @ 16 end point truncated due to lack of space in vring buffer !!!-TI中文支持网](https://www.ti2k.com/wp-content/uploads/ti2k/DeyiSupport_DSP_pastedimage1753265713483v1.jpg)