TI中文支持网
TI专业的中文技术问题搜集分享网站

关于TAS5421的单端信号输入问题!

Dear:

在TAS5421的数据手册中提到可以输入单端信号:原文如下:

When using a single-ended audio source, ac-ground the negative input through a capacitor equal in value to the
input capacitor on the positive input, and apply the audio source to the positive input. For best performance, the
ac ground should be at the audio source instead of at the device input if possible
我这样处理对吗?如下:
谢谢!
Kailyn Chen:

您好,这段主要描述了单端输入的方法,音频源接在正向端,负相端通过AC耦合电容到地,电容值大小和正相端输入耦合电容值大小相同。
最后一句提到了,AC耦合到地应该是放在音频源端,而不是靠近device端。 对地50ohm阻抗可以不用加。

user5931572:

回复 Kailyn Chen:

谢谢,根据你的分析,那么我应该去掉负向端口的地还有R12对的吧,负向端口IN_N直接接向音源的地端,是这样吗?

Kailyn Chen:

回复 user5931572:

您好,R10 和R12 都可以去掉,layout 走线的特征阻抗单端是50ohm 没错。
为了达到最佳性能,IN_N端接电容到地靠近音源端,指的是layout时将把电容靠近音源端,而不是device端。
For best performance, the ac ground should be at the audio source instead of at the device input if possible

user5931572:

回复 Kailyn Chen:

十分感谢:就像下面的连接方式对吧

Kailyn Chen:

回复 user5931572:

嗯可以的,通常差分信号单端输入时,另一个不用的引脚通过AC耦合电容到地,电容值和输入源的AC耦合容值相同即可,或者接在Vcom上,形成伪差分输入。

user5931572:

回复 Kailyn Chen:

好的,十分感谢

赞(0)
未经允许不得转载:TI中文支持网 » 关于TAS5421的单端信号输入问题!
分享到: 更多 (0)