如何让BQ25895完成充电后不再复位。

我向0X09寄存器写入0x60值，关闭了升压模式，但我发现一旦充电完成，升压5.0V又再次开启。升压会导致电池无法长时间存放，会一直消耗电量。按照正常的寄存器配置我应该是关闭了BATFET full system reset enable。但我发现不起作用，这是为什么？

Star Xu：

您看一下QON的pin 脚说明
BATFET enable/reset control input.
When BATFET is in ship mode, a logic low of tSHIPMODE (typical 1sec) duration turns on BATFET to exit
shipping mode. .
When VBUS is not plugged-in, a logic low of tQON_RST (typical 10sec) duration resets SYS (system power) by
turning BATFET off for tBATFET_RST (typical 0.3sec) and then re-enable BATFET to provide full system power
reset.
The pin contains an internal pull-up to maintain default high logic