I am using
CC1310 LaunchPad
SimpleLink 4.10.01.01, 50kps mode
915Mhz, 14dbm
sensor and collector example
CONFIG_SECURE is true
CONFIG_FH_ENABLE is true
我的問題是 接收靈敏度測試around -80dbm
然而在CC1310文檔中提到在50kbps靈敏度是-110dbm
在rfPacketErrorRate Example 中接收靈敏度是-10x dbm
然而在15.4 Stack 靈敏度降低了, 查看停止時候的RSSI的值在-80dbm,並沒有達到預期的-110dbm
Viki Shi:
请问你是用smartrf studio测试的吗?
Kevin Qiu1:
手册中的数据是在868MHz测试得到的,915MHz测试数据手册中没有提到
Larry Ho1:
回复 Viki Shi:
I have 1 sensor and 1 collector, they both are using CC1310 LaunchPad
I put debug print in both sensors and collectors. I changed
CONFIG_REPORTING_INTERVAL to 500ms
when the collector receives sensor reporting data, I can get RSSI and I will print that out.
Viki Shi:
回复 Larry Ho1:
建议直接用smartrf studio测,排除软件原因
Larry Ho1:
回复 Viki Shi:
在rfPacketErrorRate Example 中接收靈敏度是-10x dbm
在 sensor/collector example under SimpeLink CC13x0 SDK – 4.10.01.01 中接收靈敏度 around -80dbmI did it without any editing on the code, just print out LinkQuality and RSSI.
Larry Ho1:
回复 Viki Shi:
建議直接用smartrf studio測,排除軟件原因
@Viki Shi, It is means sensor/collector example has software issues?
Viki Shi:
回复 Larry Ho1:
TI官方软件没有问题,之前以为是修改过的软件。
PS:这边是中文论坛,直接用中文回复即可
Larry Ho1:
回复 Viki Shi:
在rfPacketErrorRate Example 中接收靈敏度是-10xdbm
在sensor/collector Example 中斷線時接收靈敏度大約 -80dbm
使用15.4 Stack 靈敏度降低了.
有什麼配置我可以更改使靈敏度改進?
Viki Shi:
回复 Larry Ho1:
“然而在CC1310文檔中提到在50kbps靈敏度是-110dbm 在rfPacketErrorRate Example 中接收靈敏度是-10x dbm 然而在15.4 Stack 靈敏度降低了, 查看停止時候的RSSI的值在-80dbm,並沒有達到預期的-110dbm” 我翻了一下文档,-110dbm是Receiver sensitivity,RSSI是95dB,误差±2 dB。以上数据是在868 MHz频率下测得的。RSSI在无线网络中表示信号的强度,它随距离的增大而衰减,通常为负值,该值越接近零说明信号强度越高
Larry Ho1:
回复 Viki Shi:
For 15.4 Stack sensor/collector Example
但在 -110dbm到-80dbm 難以配對 或者 發送和接收.
有什麼配置我可以更改使配對 或者 發送和接收 有改進?