TI中文支持网
TI专业的中文技术问题搜集分享网站

新做的板子,用CCS对335X进行调试,DEBUG时报错(Error -1204 @ 0x3D5B) Unable to access the DAP. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation pa

你好:

      我新做了一块板子用的是3358的片子,采用的DDR2和NAND FLASH ,现在用CCS进行DEBUG时报错

(Error -1204 @ 0x3D5B)
Unable to access the DAP. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK).
(Emulation package 5.1.232.0)

我进行Test Connection 测试显示

File:Sitara-linux-training-test-connection.png

显示没问题。

我板子 PWRONRESTn 和RTC_PWRONRESTn由FPGA提供,RTC_PWRONRESTn画图时没注意由FPGA的3V3的IO输出与要求不符合,要求为1V8,请问怎么排除问题。

Shine:

RTC_PWRONRESTn改为1.8v的了么?

chenglin guo:

回复 Shine:

改成了1V8试了,还是报一样的错,scan -test 没问题,尝试连接A8的核报这个错。

Shine:

回复 chenglin guo:

下面是对这个报错信息的解释可以参考一下。http://processors.wiki.ti.com/index.php/Debugging_JTAG_Connectivity_Problems#Cannot_access_the_DAP

检查一下电源上电时序是否正确,reset信号是否足够长?

user6199958:

请问您这个问题解决了么?能分享一下解决方法么?感谢

user6199958:

请问您这个问题解决了么?能分享下解决方法么?谢谢

赞(0)
未经允许不得转载:TI中文支持网 » 新做的板子,用CCS对335X进行调试,DEBUG时报错(Error -1204 @ 0x3D5B) Unable to access the DAP. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation pa
分享到: 更多 (0)