TI中文支持网
TI专业的中文技术问题咨询交流网站

CC1310程序仿真时出现Error -2134

CC1310下载程序出现了错误:Cortex_M3_0: Can't Run Target CPU: (Error -2134 @ 0x0) Unable to control device execution state. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 6.0.576.0)Cortex_M3_0: JTAG Communication Error: (Error -1170 @ 0x0) Unable to access the DAP. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 6.0.576.0)

怎么办,折腾了3天了,谢谢

Viki Shi:

Lost control of device execution state

This error means the device is free running and the JTAG debugger lost control of its core and status. Both a disconnect and power cycle will be required, but there is a possibility the running firmware on the device may be preventing the JTAG debugger from properly connecting (if the device has flash memory). In these cases, consult the documentation of your device to find out how to unlock it.

Error: (Error -2134 @ 0x0)
Unable to control device execution state. Reset the device, and retry the operation.If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK).

说明jtag调试器失去控制了,一般来说,断开连接或者断电重连就能恢复。

fang wang6:

回复 Viki Shi:

我重现断开好几次,都这样,换了几块儿板子都这样,好像是个共性问题,不知道怎么回事,折腾了3天了

Alvin Chen:

回复 fang wang6:

有可能是晶振不稳或者电源不稳造成的,你测量一下看看。

user5065507:

回复 fang wang6:

您好,我这边也遇到这个问题,不知道您是怎么解决的,求教,谢谢

Viki Shi:

回复 user5065507:

你可以发布新帖,描述下你的具体问题

user5065507:

回复 Viki Shi:

您好,我发了新贴,麻烦指点,谢谢

Viki Shi:

回复 user5065507:

找到你的帖了,下回可以附个链接,方便找:)

赞(0)
未经允许不得转载:TI中文支持网 » CC1310程序仿真时出现Error -2134
分享到: 更多 (0)